Documents

How to Configure Virtual Router Backup Protocol? In this article, you will find out how to configure the Virtual Router Redundancy Protocol (VRRP). Virtual Router Fallback Protocol (VRRP)...

In this article, we will examine how to create and use configuration backup files on Teltonika RUT Series devices. The configuration backup file contains all the configuration information of...

How to Create a Guest Wifi Network? Configuring the router (RUTX) Before you start configuring the router , turn on “Advanced WebUI” mode . You...

Prerequisites: A router from the RUT series or TRB140; Access to VPN network; A PoE switch or other type of power supply for the cameras; ...

IPsec can protect data flows between a pair of hosts (host to host), between a pair of security gateways (network to network), or between a security gateway and a host...

UC200: 192.168.12.12 Analog Gateway (FXO): 192.168.12.13 We are adding an extension on the switchboard. Extension Trunk must be set to True in the Advanced...

UC200: 192.168.12.12 Analog Gateway(FXO): 192.168.12.13 UC200 Settings We create a trunk on the switchboard for the FXO gateway. (192.168.12.13:5060) Read more

Synway FXS Gateway Port Registration Procedures From the Voip => Sip tab, enter the IP address of the switchboard to be registered.

How to Change IP Address? We can change the interface IP address from the System Tools...

How to Access Synway FXS Gateway Interface? There are two ethernet ports on the device. We can access the interface through these ports. LAN1: 192.168.1.101 LAN2: 192.168.0.101 ...

The target number of the incoming call is defined in the DID Number section. To run the accept-all rule in this definition, the DID pattern section can be left blank...

How to Set Synway PBX Inbound, Outbound? Step 1 We log in to the interface of our Synway switchboard. We click on PBX > Trunk > Add....

How to Set PBX Date and Time? You can access the date and time settings page in System>Date Time Settings. Read more

This In the application, we will add the T46S phone to the switchboard with autoprovision.

How to Create IVR? To...